Installing The Optional Head End Storage Flat - Stryker Power-PRO IT 6510 Bedienungs- Und Wartungshandbuch

English

INSTAllING THE OPTIONAl HEAD END STORAGE FlAT

To install the optional head end storage flat (see Figure 26):
1. Install the Velcro
2. Buckle the restraint straps (B) around the outer rails of the retractable head section.
WARNING
When the optional head end storage flat is being used, ensure that it does not interfere with the operation of the
retractable head section, safety bar and safety hook. Injury to the patient or operator could result.
CAUTION
The weight of the equipment in the head end storage flat (if equipped) must not exceed 40 pounds (18 kg).
Return To Table of Contents
1-48
Cot Operation
straps (A) near the pneumatic cylinder and around the cross bar of the retractable head section.
®
B
Cross Bar
Figure 26: Head End Storage Flat
A
A
V-Tube
6510-009-005 REV A
B
www.stryker.com