Unloading An Empty Cot From A Vehicle With One Operator - Powered Method - Stryker Power-PRO IT 6510 Bedienungs- Und Wartungshandbuch

English

UNlOADING AN EMPTy COT FROM A VEHIClE WITH ONE OPERATOR - POWERED METHOD

Unloading an unoccupied cot from a vehicle can be accomplished by a single operator.
WARNING
• The one person loading and unloading procedures are for use only with an empty cot. Do not use the procedures
when loading or unloading a patient. Injury to the patient or operator could result.
• Do not pull or lift on the safety bar when unloading the cot. Damage to the safety bar could result and injury to
the patient or operator could occur.
• Ensure proper hand placement on hand grips. Hands should be clear of red safety bar pivots while loading and
unloading the cot.
To unload an empty cot from a vehicle with one
operator:
1. Lift the vehicle bumper to the raised position (if
equipped).
2. Disengage the cot from the cot fastener. (For more
information about the cot fastener, see
3. Grasp the cot frame at the foot end.
4. Pull the cot from the vehicle until the safety bar
engages the safety hook.
5. Depress the extend (+) button to lower the
undercarriage to its fully extended position as shown
in Figure 17.
6. Disengage the safety bar from the safety hook by
pulling the safety bar release lever forward and roll
the cot out of the vehicle.
7. Remove the load wheels from the patient compartment
of the vehicle.
CAUTION
• When unloading the cot from the patient compartment, ensure that the caster wheels are safely set on the ground
or damage to the product may occur.
• Do not "jog" the cot past the load height while the safety bar is engaged.
Return To Table of Contents
1-36
Operation Guide
page 1-23).
Figure 17: Press the Extend Button
6510-009-005 REV A www.stryker.com