Stryker Power-PRO IT 6510 Bedienungs- Und Wartungshandbuch Seite 21

Item
Litter All fasteners secure (reference all assembly drawings)
All welds intact - not cracked or broken
No bent, broken, or damaged components
Inspect hand grips - no defects or tears
Head Section All fasteners secure (reference all assembly drawings)
No bent or broken tubing or sheet metal
Verify the head section extends and retracts properly
Inspect grip on lift bar - no defects or tears
Load wheels are secure and roll freely
Verify the safety bar operates properly
Base All fasteners secure (reference all assembly drawings)
All welds intact - not cracked or broken
No bent, broken, or damaged components
Wheels and Tires No debris in wheels
All wheels secure, rolling and swiveling properly
Operate wheel locks (if equipped) - wheel secure when engaged,
rolls freely when disengaged
Cot Fastener Inspect the cot retaining post - fasteners secure
Install in-fastener shut-off module.
Determine and set in-fastener shut-off position.
Verify the cot and cot fastener fit and function properly.
Install vehicle safety hook
Verify the safety bar engages the vehicle safety hook properly
Accessories Verify head end storage flat (if equipped) is installed properly
www.stryker.com
Product Inspection
Routine
6510-009-005 REV A
Page
1-46
1-32
1-47
1-74
1-24
1-26
1-32
1-48
Return To Table of Contents
1-21
English