Wheel Locking Force Adjustment; Cot Retaining Post Adjustment - Stryker Power-PRO IT 6510 Bedienungs- Und Wartungshandbuch

English

WHEEl lOCKING FORCE ADJUSTMENT

Tools Required:
• 5/32" Allen Wrench
• 7/16" Combination Wrench or Socket
Procedure:
1. Using the 5/32" Allen wrench and 7/16" combination wrench or socket, remove the socket screw from the center of
the lock pedal. The wheel lock is initially assembled with the pedal set at the minimum locking force. The marker
on the pedal (A) is aligned with the marker on the octagonal sleeve (B).
2. Remove the sleeve (B). Rotate the sleeve counterclockwise to increase the pedal locking force and clockwise to
decrease the locking force. Insert the sleeve into the pedal.
3. Using the 5/32" Allen wrench and 7/16" combination wrench or socket, reinstall the socket screw.
4. Test the pedal locking force and verify that the pedal holds properly before returning the cot to service.
MINIMUM

COT RETAINING POST ADJUSTMENT

Tools Required:
• 3/16" Allen Wrench
CAUTION
The cot retaining post comes
preconfigured for an X-frame cot,
if the fastener has been configured
for an H-frame style cot, the cot
retaining post must be adjusted to
accommodate the fastener.
Procedure:
1. Using a 3/16" Allen wrench,
remove the bolts that hold the
two retaining post brackets to
the base frame.
2. Turn the bottom bracket 180˚.
3. Using a 3/16" Allen wrench,
reinstall the bolts that were
removed in step 1.
Note: If the arrow on the bottom bracket of the retaining post points toward the head end of the cot, the retaining post
is set for an X-frame style cot. If the arrow points toward the foot end of the cot the post is set for an H-frame style cot.
Return To Table of Contents
1-74
Service Information
Figure 35: Wheel locking Force Adjustment
Retaining
Post
Bottom
Bracket
Figure 36: Cot Retaining Post
6510-009-005 REV A
MAXIMUM
Arrow
Bottom View
www.stryker.com