Incubator - Stryker Power-PRO IT 6510 Bedienungs- Und Wartungshandbuch

INSTAllING THE DRAGER
Prior to installing the Drager
®
the manual supplied with the incubator.
WARNING
• The Drager ® Incubator adaptor (6510-029-000) is designed to secure only Drager
PRO™ IT cot. Using this adaptor on any cot other than the model 6510 Power-PRO™ IT cot or using any
unapproved incubators on this adaptor may result in damage to the cot and/or injury to the patient or user.
• Stryker is not responsible for specifications changes to the Drager
To install the incubator:
1. Pull the red latch handle (A) on the adaptor and move it to the right until the slot in the handle engages with the
shoulder bolt (B) on the adaptor as shown in Figure 28.
2. Place the incubator on the adaptor. Align the holes in the incubator with the four pins (C) on the adaptor (only 2
of the 4 pins are shown).
3. Move the latch handle to the left to release it. The handle retracts and the latches engage to secure the incubator.
Inspect all four locking points to verify that the latches are securely engaged and are not obstructed by anything
(hoses, wires, etc.).
www.stryker.com
Cot Operation

INCUBATOR

®
Incubator on the model 6510 Power-PRO™ IT cot, read and understand this manual and
C
C
C
C
Figure 28: Drager
6510-009-005 REV A
® incubators to the 6510 Power-
® (or Air-Shields ® Series) incubators.
® Incubator
B
B
A
A
Return To Table of Contents
1-51
English