Stryker Power-PRO IT 6510 Bedienungs- Und Wartungshandbuch Seite 44

English
USING THE BATTERy POWER INDICATOR
To check the battery power level, depress lightly on the retract (–) switch (A) to activate the power indicator LED (B)
as shown in Figures 22.1 and 22.2.
The power indicator LED is located at the foot end control enclosure as shown in Figure 22.2, represented by a battery
icon.
• The indicator LED is solid green when the battery is fully charged or has adequately charged battery power.
• The indicator LED flashes red when the battery needs to be recharged or replaced.
A
Figure 22.1: Retract Switches
WARNING
• To avoid risk of electric shock, never attempt to open the battery pack for any reason. If the battery pack case
is cracked or damaged, do not insert it into the charger. Return damaged battery packs to a service center for
recycling.
• Do not remove the battery when the cot is activated.
• Avoid direct contact with a wet battery or battery enclosure. Contact may cause injury to the patient or operator.
CAUTION
• Only use the battery and charger as specified.
• The cot is not for use with an AC adapter.
• When charging a battery in an ambulance, locate the charger in an enclosed cabinet and out of patient reach
during transport.
• Ensure that the battery is fully charged prior to placing into service. An uncharged or depleted battery may cause
poor cot performance.
See the SMRT Power System Operations/Maintenance manual (6500-009-101) for additional SMRT Pak and SMRT
Charger information. See the
Return To Table of Contents
1-44
Operation Guide
Battery System manual for battery and charger information.
D WALT ®
e
6510-009-005 REV A
B
Figure 22.2: Power Indicator lED
www.stryker.com