Stryker Power-PRO IT 6510 Bedienungs- Und Wartungshandbuch Seite 15

CAUTION (CONTINUED)
• DO NOT STEAM CLEAN OR ULTRASONICALLY CLEAN THE UNIT.
• Maximum water temperature should not exceed 180°F/82°C.
• Maximum air dry temperature (cart washers) should not exceed 240°F/115°C.
• Maximum water pressure should not exceed 1500 psi/130.5 bar. If a hand held wand is being used to wash the
unit, the pressure nozzle must be kept a minimum of 24 inches (61 cm) from the unit.
• Towel dry all casters and interface points.
• Failure to comply with these instructions may invalidate any/all warranties.
• Always remove the battery before washing the cot.
• A preventative maintenance program should be established for all Stryker EMS equipment. Preventative
maintenance may need to be performed more frequently based on the usage level of the product. Close attention
should be given to safety features including, but not limited to:
• Hydraulic power mechanism
• All electrical controls return to off or neutral position when released.
For additional maintenance information, see the preventative maintenance information.
• Improper maintenance can cause injury or damage to the product. Maintain the cot as described in this manual.
Use only Stryker approved parts and maintenance procedures. Using unapproved parts and procedures could
cause unpredictable operation and/or injury and will void the product warranty (see
• Failure to use authorized parts, lubricants, etc. could cause damage to the cot and will void the warranty of the
product.
• Hydraulic lines, hoses, and connections can fail or loosen due to physical damage, kinks, age, and exposure.
Check hoses and lines regularly to avoid damage to the cot. Check and tighten loose connections.
• Do not tip the cot onto its load wheels and actuate the product as this will allow air to enter the hydraulic system.
• Do not lubricate the bearings in the X-frame as it will degrade the performance of the cot and may void its warranty
(see page 1-86).
• The cot retaining post comes preconfigured for an X-frame cot, if the fastener has been configured for an H-frame
style cot, the cot retaining post must be adjusted to accommodate the fastener.
• When using a single incubator, you must use the center mounting or tipping may occur.
• If an obstacle is encountered while using the foot end push bars, use extreme caution as the head end may tip.
• Carefully store equipment in the cot to prevent them from being jammed in the mechanism.
• Do not lift the head end of the cot by using the head extension. The extendable head section should be used
when lifting the head end of the cot.
• The incubator should only be moved when the cot is at its lowest position.
• To avoid malfunction, the model 6510 Power-PRO™ IT cot should not be used adjacent to or stacked with other
equipment. If adjacent or stacked use is necessary, the model 6510 Power-PRO™ IT cot should be observed to
verify normal operation in the configuration in which it will be used.
• The model 6510 Power-PRO™ IT cot is not designed to transport more than one incubator.
www.stryker.com
Summary of Safety Precautions
6510-009-005 REV A
page 1-86).
Return To Table of Contents
1-15
English