Kärcher CB 5/23 Originalbetriebsanleitung Seite 45

Display Fault
179 CAN bus error, module A8, no connection
(in the main control cabinet)
180 CAN bus error, module A8, no connection
(in the main control cabinet)
181 CAN bus error, module A9, no connection
(high pressure distributor to portal)
183 CAN bus error, module A5 no connection
(water distributor CB 5)
CAN bus error, module A15, no connec-
tion (water distributor CB Flex)
184 CAN bus error module A6 no connection
(water distributor CB 5)
CAN bus error, module A16, no connec-
tion (water distributor extension CB Flex)
185 CAN bus error module A29, no connection
(water distributor)
186 CAN bus error module A30, no connection
(side brush inclination)
187 CAN bus error module A31, no connection
(Basic gate control)
188 CAN bus error module A19, no connection
(cycle unit)
189 CAN bus error module A20 no connection
(underbody wash Christ)
190 Excess current outlets CAN bus module
A8 (in the main switch cabinet)
191 Excess current outlets CAN Bus module
A9 (high pressure distributor to portal)
193 Excess current outputs CAN bus module
A5 (water distributor CB 5)
Excess current outputs CAN bus module
A15 (water distributor CB Flex)
194 Excess current outputs CAN bus module
A6 (water distributor CB 5)
Excess current outputs CAN bus module
A16 (water distributor extension CB Flex)
195 Excess current outlets CAN Bus module
A29 (pump switching cabinet)
196 Excess current outlets CAN bus module
A30 (side brush inclination)
197 Excess current outlets CAN bus module
A31 (Basic gate control)
198 Excess current outlets CAN Bus module
A19 (cycle unit)
199 Excess current outlets CAN Bus module
A20 (underbody wash Christ)
200 Control voltage is missing
201 Plant not in operation (operational time
switched off)
202 Vehicle movement device not in home po-
sition
203 Portal not in normal setting
204 Side-brushes not facing outwards
205 Side-brush 1 not facing outwards
206 Side-brush 2 not facing outwards
208 Roof brush not facing upward
209 Drier 1 not at the top
Possible cause
Loose connecting chord of the plates,
plates defective
Loose connecting chord of the plates,
plates defective
Short circuit, water leakage
Emergency stop pressed, protective
switch triggered, reset button has not
been pressed
Night switch off of the unit is active, key
switch of the feed distributor is posi-
tioned at "0"
Unit not in normal setting
20
-
EN
Remedy
Switch off and switch on the unit, repeat
washing process, call Customer Service
Press all emergency stops, check that all
protective motor switches have been
switched on, press reset button in the con-
trol station
Check key switch of the feed distributor
(position it to 1 or 2)
Move the vehicle movement device to its
home position
Drive unit to normal setting
45