Kärcher CB 5/23 Originalbetriebsanleitung Seite 38

Number of Fault
blinks
once Wheel washing 1 not facing outwards
twice Wheel washing 2 not facing outwards
thrice Short/ narrow hall switch pressed (Option) The switch has been pressed by a
four times Press safety switch roof drier
5 times Frost protection active (option)
6 times Vehicle width switch has been pressed
(Option)
38
Fault display Positioning ramp
1 Drive forward
2 Reverse drive
If the "drive forward" and "drive backwards"
signal of the positioning light flashes simul-
taneously, one of the malfunctions men-
tioned below has occurred.
Possible cause
Wheel washing is not in basic posi-
tion
person
Check switching bracket and its limit
switch for damages
Frost proteciton is active
Vehicle is too broad or has been po-
sitioned wrongly
13
-
EN
Remedy
Check compressed air supply, check
mechanical components of wheel
washing 1
Check compressed air supply, check
mechanical components of wheel
washing 2
One or more switches have been
pressed; reset switch manually
Press the "Start/Stop" key.
Check the switch, call Customer Ser-
vice
Washing cannot be done until the anti-
frost temperature is exceeded again
One or more switches have been
pressed; reset switch; re-position the
vehicle