Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connecting the System
Connecting the battery power cables
• Use the cable box power cables to connect
the respective side poles of the cable box
and the battery module mounted underneath (3.1).
To do this, connect red to red (BAT+) and black
to black (BAT-) respectively.
• To connect additional battery modules, connect their
power cables to the respective side poles as shown
as an example for the system setup with 2 battery
modules (3.2).
Detailed connection sketches depending on the num-
ber of battery modules can be found in the
corresponding cable set section under "Packing list".
Note:
You can connect up to 8 battery storage
modules to the system.
However, only install a maximum of 2 modules
on top of each other below the inverter and the
cable box and others to the side if necessary
(For illustration see mounting chapter).
• Close all covers again.
118
3.1
3.2
Werbung
