KKT KOLBE HKW10NVP3 Benutzerhandbuch Seite 247

Mounting the inverter
• Place the inverter bracket on the mounting plate
of the upper battery module,
so that the corresponding screw holes are on top of
each other (see 5),
mark the position of the upper screw holes on the wall
and remove the bracket again.
• Drill the additional marked points
each with a Ø10mm drill approx. 70mm deep.
• Tap 2 dowels D10 × 50 into the drill holes
with a rubber mallet.
• Put the bracket back on and fix it to the wall
with 4 screws, type ST6.3×50 (5.1).
• Hang the inverter on the bracket (6).
• Fix the inverter to the battery module by screwing 2
screws, type M5 × 12 into each of the screw holes of
the fixing plates on the left (7.1) and right side (7.2)
at the rear of the system.
• Also fix the inverter to the wall bracket by screwing
1 screw, type M5 × 12 into each of the screw holes
on the left and right side.
• Make sure that the system is mounted stably.
Mounting the System
5.1
7.2
5
6
7
7.1
111