KKT KOLBE HKW10NVP3 Benutzerhandbuch Seite 200

Operation and Setting
CEI SPI control
This option is for DRM requirements in Australia and
New Zealand only and can be ignored for other grid standards.
When the DRM signal is enabled, this is used as a local signal.
When the DRM signal is enabled, when the CEI SPI Ctrl is
enabled, the frequency range is 50.2 Hz - 49.BHz.
When the CEI SPI Ctrl is disabled, the frequency range is
51.5Hz - 49.8 BHz.
Use the up/down keys /
to select the desired one of the two options:
1: CEI SPI disabling
2: CEI SPI enabling
Use the enter key
or the escape key
to the system setting options.
GFCIenabling(GFCICHKENB)
This option is used to enable the internal circuit breaker
for ground fault monitoring on the AC grid connection.
Use the up/down keys / to select the desired one
of the two options:
1: GFCI disabling
2: GFCI enabling
Use the enter key
or the escape key
to the system setting options.
64
to confirm your selection
to cancel the process and return
to confirm your selection
to cancel the process and return
−CEI SPI CTRL−
1. DISABLE
2. ENABLE
−GFCICHK ENB−
1. DISABLE
2. ENABLE