KKT KOLBE HKW10NVP3 Benutzerhandbuch Seite 246

Mounting the System
• Reposition the battery bracket / mounting plate as pre-
viously described and fasten it to the battery module (2)
with the 2 screws supplied, type M5×12 (2.1).
• Fix the battery storage module with the mounting plate
to the wall by screwing the 4 screws,type ST6,3×50
with the M6 seals into the dowels (3.1).
• Repeat these steps accordingly
for mounting the second battery storage module (4)
or further modules.
Use only the two outer screws for fastening the module
over which the inverter is to be mounted (4.1).
Note:
You can connect up to 8 battery storage
modules to the system.
However, only install a maximum of 2 modules
on top of each other below the inverter and the
cable box and others to the side,
as illustrated in the following figure:
110
2.1
2
3.1
3
4.1
4