KKT KOLBE HKW10NVP3 Benutzerhandbuch Seite 203

Battery Setting
Use the up/down keys / to select the one you want
to access from the following system parameters:
1: Battery type
2: Discharge depth
3: Off-grid DOD (depth of discharge)
4: Charging current
5: Discharge power
6: Charging power
7: Battery end voltage
8: Battery wake-up
9: Heating film
10: BMS DOD
(Battery management system - Depth of discharge)
11: Maintain SOC (State of discharge) / Minimum charge
12: Force wake-up
To confirm your selection and enter the corresponding
settings menu, use the enter key .
To return to the setup options instead,
use the escape key .
Battery type (BAT TYPE)
The default setting (LFP) already corresponds to the
battery type of the KKT Power Sets.
To change the current setting, use the up/down keys /
to select the desired battery type from the following:
1: Lead-acid battery
2: Lithium ferrous phosphate battery (Default setting)
To confirm your selection and enter the corresponding
settings menu, use the escape key .
To return to the battery setting options instead,
press the escape key .
Operation and Setting
−−BAT SETTING−−
1: BAT TYPE
2: DISC-DEPTH
3: OFFGRID DOD
4: CHG CURR
5: DISC POWER
6: CHG POWER
7: BAT END VOLT
8: BAT WAKE-UP
9: HEATING FILM
10: BMS DOD
11: MaintainSOC
12: Force Wake
−−BAT TYPE−−
1: LEAD-ACID
2: LFP
67