KKT KOLBE HKW10NVP3 Benutzerhandbuch Seite 199

Remote control
Activating this option enables the system to be controlled
via the RS485 interface (e.g. Scada system).
By default, this option is disabled.
To change the current setting, use the up/down keys /
to select the desired one of the following options:
1: Remote control option disabling
2: Remote control option enabling
Use the enter key
or the escape key
to the system setting options.
Note: The energy storage system can optionally be
remotely monitored via Wi-Fi / App as described in the
corresponding sections.
Start-up delay / Start time
The boot delay of the inverter after applying power
is to ensure that all system components are fully operational
at the start time and that false starts are avoided.
The input value for the boot delay can be set from 20 to 300
seconds and varies depending on the set grid standard.
It is recommended not to change the default setting.
Use the up/down keys / to adjust the input value
and the enter key
To cancel the process and return to the system setting op-
tions, use the escape key .
to confirm your selection
to cancel the process and return
to confirm.
Operation and Setting
−REMOTE CTRL−
1. DISABLE
2. ENABLE
START-UP DELAY
INPUT: 60
UNIT: SEC
63