Status Leds For Digital Outputs; Led For Operating Status Of The Cf Card; Microphone Input, Loudspeaker Output - HBM QUANTUM X Bedienungsanleitung

CX22-W
A3169-5.0_en/de
LEDs 4 to 6. The LEDs light up when the relevant output
is set to HIGH.

12.3.4 Status LEDs for digital outputs

The LEDs show the status of digital outputs 4 to 6. The
outputs are addressed via LEDs 4 to 6 in catman
EASY.
Set the outputs via limit value and event monitoring:
Enter 0 HIGH (LED 4) under Bit/Condition if output 4
should become active when the event occurs (LED 4
lights up green). Outputs 5 and 6 are activated via Bit 1
(LED 5) and Bit 2 (LED 6).
Tip
At the start of a DAQ job, outputs are reset to LOW if you
activate the setting Reset all CX22-W digital outputs
on DAQ start in the options for the CX22-W (System
group) in catman

12.3.5 LED for operating status of the CF card

The LED on the rear of the module flashes yellow when
data are written to or read from the CF card.

12.4 Microphone input, loudspeaker output

The microphone input allows you to connect a standard
PC microphone (powered by the CX22-W).
[
EASY.

75