Safety Instructions - HBM QUANTUM X Bedienungsanleitung

CX22-W
1

Safety instructions

A3169-5.0_en/de
Appropriate use
The QuantumX data recorders CX22-W (with WLAN) are
to be used exclusively for measurement tasks and
directly related control tasks within the application limits
detailed in the specifications. Use for any purpose other
than the above is deemed to be non-designated use.
In the interests of safety, the module should only be
operated as described in the Operating Manuals. It is
also essential to comply with the legal and safety
requirements for the application concerned during use.
The same applies to the use of accessories.
Each time you start up the module, you must first run a
project planning and risk analysis that takes into account
all the safety aspects of automation technology. This
particularly concerns personal and machine protection.
Additional safety precautions must be taken in plants
where malfunctions could cause major damage, loss of
data or even personal injury. In the event of a fault, these
precautions must establish safe operating conditions.
This can be done, for example, by mechanical
interlocking, error signaling, etc.
Note
The module must not be connected directly to the power
supply system. Supply voltage 10 V ... 30 V (DC).
5