Start/Stop Button; Led Displays - HBM QUANTUM X Bedienungsanleitung

CX22-W
A3169-5.0_en/de

12.2 START/STOP button

You can start and/or stop a DAQ job with the
START/STOP button. To do this, use a trigger to start
and/or stop the DAQ job, and assign CX22-W digital
input 3 - START/STOP button as the trigger channel. If
you control the start and stop of the DAQ job via the
button, the DAQ job is started with the first press and
stopped with the next press of the button.
Important
The START/STOP button is switched parallel to the input
on terminal 3. So if you want to use the push button, do
not connect input 3. Otherwise the condition "Active"
(LOW) will be triggered by pressing the button and by a
LOW signal at terminal 3.

12.3 LED displays

The following LED displays exist:
1. Module LED,
2. LEDs in the Ethernet connection,
3. Status LEDs for operating status,
4. Status LEDs for digital outputs,
5. LED for operating state of CF card (rear of module).
73