Connecting To A Pc - HBM QUANTUM X Bedienungsanleitung

24
DVI monitor cable to the DVI socket (see Fig. 4.1 on
Page 15 for all connections). Connection via VGA is not
possible, not even with a DVI/VGA adapter plug, as the
leads required for VGA are not assigned.
Switch on the power supply and wait until the boot
process is complete and the module is ready.
Important
The CX22-W factory setting for the input language
(keyboard layout) is EN (English). If you connect a
keyboard with a different layout, you should select Exit
to Windows on the start screen and press Alt, or change
the input language via the language bar in the task bar.
If necessary, use the Windows control panel ("Regional
and Language Options") to set the (Location) to your
country. The setting influences, the digit settings and the
time, for example.
Make other settings via the start screen (CX22-W Start
screen), see Chapter 9.
Tip
See also Chapter 11,
Configuring the CX22-W for self-contained measurements
from Page 70.
6.3

Connecting to a PC

In this case, the CX22-W data recorder is connected to
the PC via Ethernet. There are different variants,
depending on your PC/network configuration, and the
connection procedure depends on the variant:
CX22-W
,
A3169-5.0_en/de