Configuring The Cx22-W For Self-Contained Measurements - HBM QUANTUM X Bedienungsanleitung

11 Configuring the CX22-W for self-contained
measurements
70
Important
With the CX22-W data recorder, the Windows Autostart
folder is not suitable for automatically running other
programs during Windows startup. The entries there are
only evaluated when the start screen is terminated by
Exit to Windows. The programs to run during startup
can only be specified via the Windows Registry.
Settings must be made in two areas to configure the
CX22-W for self-contained measurement:
1. You must implement the applicable settings in DAQ
Jobs and Options in catman
EASY loads a DAQ project and launches the DAQ job
after startup.
2. You must ensure that catman
CX22-W is switched on.
As usual, measurement start and stop can be
implemented immediately, or via a trigger. You can also
use the CX22-W START/STOP button, see Section 12.2
on Page 73.
Procedure
1. Configure the DAQ project as described in Section
10.4. Set up the DAQ jobs so that the data are saved
with the Automatically on DAQ termination setting
(Data saving in the Group Settings, Data storage
parameter).
2. Save the DAQ project.

EASY so that catman

EASY starts when the
A3169-5.0_en/de
CX22-W
