Creating A Daq Project - HBM QUANTUM X Bedienungsanleitung

CX22-W
A3169-5.0_en/de
In Search ports, activate the interface via which your
devices are connected, e.g. FireWire. For an Ethernet
connection, enter the address range to browse (Scan
range for TCP/IP device scan) or use the QuantumX
device manager.
Tip
Only search the interface which has a device connected.
Use the QuantumX device manager to make the
necessary settings when first connecting to QuantumX
via Ethernet. No address is required for QuantumX and
FireWire.

10.4 Creating a DAQ project

A DAQ project contains all settings for the devices used,
transducers (sensors), real time calculations, how the
measurement is to be carried out and which data should
be saved. You can also configure a visualization if a
monitor is connected to the CX22-W data recorder.
Procedure
1. In the CX22-W data recorder start screen, click on
Start DAQ software.
2. Select New DAQ project.
When a new DAQ project is started, the interfaces
activated in the device scan are browsed. The devices
must be switched on and ready for operation,
otherwise they will not be found. You must therefore
wait after switching on the devices before carrying out
a device scan.
63