Transferring Data/Files From The Cx22-W To The Pc - HBM QUANTUM X Bedienungsanleitung

66
Important
The "ERROR" LED glows yellow if there is an error in
[
catman EASY, e.g. if the connection to devices cannot
be set up at the start of the project, or if the DAQ job
cannot be started. The "ERROR" LED flashes if the
available free memory drops below 1 GByte.
Tip
Additional information about catman
found in the catman
10.5 Transferring data/files from the
CX22-W to the PC
There are several ways to transfer the measurement
data acquired by the CX22-W data recorder to your PC:
1. Directly from the CF card.
Switch off the module, remove the CF card and plug
the card into your PC. Then copy the data from the
card.
2. Via USB memory, e.g. a USB memory stick.
Plug the USB memory into one of the CX22-W's USB
interfaces and connect the keyboard and monitor. In
the start screen, click on Exit to Windows and use
the operating system (Windows Explorer) to copy the
files.
3. Data exchange via the clipboard.
[
EASY online Help.
CX22-W
[
EASY can be
A3169-5.0_en/de