Configuring The Cx22-W For Automatic Measurements - HBM QuantumX CX22-W Bedienungsanleitung

QuantumX Data Recorder CX22‐W
9 Configuring the CX22‐W for automatic measurements
Settings in two areas must be implemented to configure the CX22‐W for
autonomous measuring:
1. You must implement the applicable settings in DAQ jobs and Options in
®
catman AP so that catman
DAQ job after startup.
2. You must ensure that catman
switched on.
Measurement start and stop can be implemented as usual immediately or via
a trigger. You can also use the START/STOP button of the CX22‐W, see Sec­
tion 10.2 on Page 35.
Procedure
1. Configure the DAQ (data acquisition) project as described in Section 8.2.
Set up the DAQ jobs so that the data are saved with the Automatically
on DAQ termination setting (Data storage in the group Settings, para­
meter Data saving).
2. Save the DAQ project.
3. Call up the catman
(group System).
4. Select an Existing DAQ project for the Start mode and select the project
created above in the DAQ project line.
5. Activate the option Execute first DAQ job automatically.
6. Go to DAQ channels in the group Channels and sensors.
7. Activate the option Deactivate defective channels and continue with
DAQ (If channel initialization fails).
8. Exit the dialog by clicking on OK.
®
9. Exit catman
10. In the start screen, click on Settings.
11. In the General tab, activate the option Launch DAQ software (cat­
manAP) at startup and click on OK.
12. Click on Commit changes and reboot to permanently save the new set­
tings.
This project will then be automatically started when the CX22‐W is switched
on again. If the power supply is interrupted during measurement, the project
will be reloaded and measurement continued when the power supply is
restored. The new start of the module up to continuation of measurement will
require approx. 3 minutes, dependent on the number of connected devices
and channels.
A3169-1.0 en/de
®
AP loads a DAQ project and launches the
®
®
AP Options (File menu) and go to Program start
AP.
AP is started when the CX22‐W is
33
HBM