Configure Measurements With Catman; Set Up Device Scan; Create A Daq (Measurement) Project - HBM QuantumX CX22-W Bedienungsanleitung

30
8

Configure measurements with catman

®
Start catman AP via Start DAQ software in the start screen of the CX22‐W
Data Recorder. The default language for catman
select German or French via Settings in the start screen, see Section 11.1 on
Page 39.
If you do not connect the QuantumX modules via FireWire, you must first spe­
cify how the connected devices can be found (device scan).
Detailed information about using catman
Help. Please also note that HBM offers seminars on catman
-> Seminars).

8.1 Set up device scan

The device scan options can be called up in the start window of catman
and Configure device scan.
Activate the Ethernet interface in Search ports and enter the address range
of the search (Scan range for TCP/IP device scan).
Tip
Only search the interfaces which have devices connected. Use the QuantumX
device manager to make the necessary settings for the initial setting with
QuantumX and Ethernet. No address is required for QuantumX and FireWire.

8.2 Create a DAQ (measurement) project

A DAQ (data acquisition) project contains all settings for the devices used,
transducers (sensors), real‐time calculations, how the measurement is to be
performed and which data should be saved. You can also configure a visualiz­
ation if a monitor is connected to the CX22 Data Recorder.
Procedure
1. Click in the start screen of the CX22‐W Data Recorder on Start DAQ soft­
ware.
2. Select New DAQ project.
When a new DAQ project is started, the interfaces activated in the device
scan are searched for. The devices must be switched on and ready for
operation, otherwise they will not be found. You must therefore wait after
switching on the devices before carrying out a device scan.
HBM
QuantumX Data Recorder CX22‐W
[
®
AP is English, you can also
®
AP can be found in the Online
AP
®
(www.hbm.com
®
AP
A3169-1.0 en/de