Inhaltsverzeichnis
Werbung
Ê Fasten the diode, rectifier/regulator lead and AC magneto cou-
pler (connected to the CDI unit), with the diode at its white tape
and the rectifier/regulator lead at its protecting tube.
Ë Fasten the wire harness, starter motor lead and negative bat-
tery lead so that the plastic locking tie ends do not contact the
ignition coil lead.
Ì Fasten the wire harness, rectifier/regulator lead, coolant reser-
voir hose, hot starter cable, negative battery lead and starter
motor lead.
Í Fasten the wire harness, negative battery lead, starter motor
lead, rectifier/regulator lead and coolant reservoir hose at the
white tape for the negative battery lead.
Î Fasten the wire harness at its white tape.
Ü 3
Û F
0
I
B-B
0
1 È
Ù F
Ú
H
G
Ù F
D
E
9
Ø C
× B
Ö 3
8
B
Ô 0
Õ 3
CABLE ROUTING DIAGRAM
Ï Fasten the wire harness, throttle position sensor lead (in the
wire harness), starter motor lead and negative battery lead.
Ð Make sure that the throttle position sensor coupler does not go
outside the chassis.
Ñ Fasten the throttle position sensor lead.
Ò Pass the carburetor breather hoses, carburetor overflow hose
and coolant reservoir breather hose between the connecting
rod and cross tube (frame).
Ó Fasten the neutral switch lead and oil hose together with the
plastic locking ties and cut off the tie ends.
Ô Pass the cylinder head breather hose through the hose guides.
Õ Fasten the neutral switch lead.
L
J
2 É
K
J
3 Ê
4 3 Ë
3 Ì 5
3 Í
6
3 Î
B
A
3 Ó
0 Ô
9
2 - 99
SPEC
A
Ý
3 Ï
Ð
3 Ñ
7
A
Ò
8
Werbung
Inhaltsverzeichnis
