Installing The Optional Head End Storage Flat - Stryker Performance-PRO XT Bedienungsanleitung

Installing the backrest storage pouch (Continued)

Installing the optional head end storage flat

WARNING
Do not allow the head end storage flat (if equipped) to interfere with the operation of the retractable head section,
safety bar, or vehicle safety hook.
CAUTION
Do not load the head end storage flat above the safe working load of 40 lb (18 kg).
To install the head end storage flat
1. Install the Velcro® straps (A) near the pneumatic cylinder and around the cross tube (C) of the retractable head
section.
2. Buckle the restraint straps (B) around the outer rails of the retractable head section.
www.stryker.com
Operation
Figure 1-35: Backrest storage pouch
(Figure 1-36 on page 1-46):
6086-209-005 REV G
English
EN
1-45