Transporting A Patient With The Big Wheel; Positioning Or Stowing The Head End Push Handles Option - Stryker Prime Series Stretcher Bedienungsanleitung

Transporting a patient with the Big Wheel

WARNING
• Always position the patient in the center of the product.
• Always lock the siderails in the full up position with the sleep surface horizontal and in the lowest position when you
transport a patient.
CAUTION
Do not apply the steer pedal when the Big Wheel is resting on a threshold or other raised area. The force required to
apply the Big Wheel will be higher than normal which may cause product damage.
To transport a patient with the Big Wheel:
1. Raise the siderails to the highest position. Pull on the siderail to make sure that it is latched.
2. Lower the litter to the lowest position.
3. For Model 1125 only, make sure that the On/Drive-Off/Manual switch is in the Off position.
4. Unplug the power cord from the wall outlet if your product is equipped with the electric lift or electric litter option.
5. Put the brake/steer pedal (A) in the steer position
6. Use the push handles to push the product.
7. Apply the brakes to lock the product in place.
Notes
• Always make sure that the brake is released before you attempt to move the product. Attempting to move the
product with the brakes applied may result in operator or patient injury.
• The Big Wheel (B) does not pivot. You cannot move the product sideways with the Big Wheel applied.
• When the Big Wheel is applied, the product is raised and the foot end casters are elevated. The product rests on
the head end casters and the Big Wheel to make the product easier to steer.

Positioning or stowing the head end push handles option

To position or stow the head end push handles:
1. Pivot the handles (A) up from the head end of the product
2. Push down on the handles to lock them into position.
www.stryker.com
Operation
(Figure 1-9 on page 1-24).
(Figure 1-10 on page
1115-409-005 REV E
1-26).
English
EN
1-25