Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Adapting the Armrests to the Forearm Length
1. Loosen the two set screws on the underside of the armrest
using a 3 mm Allen wrench. On the side where the control
panel is mounted, three set screws have to be loosened
(see Fig. 11).
2. Move the armrest with the control panel receiver or the
replacement tube along the attachment rail forwards or
backwards into the desired position.
3. Firmly retighten all set screws.
Fig. 11
Adapting the armrests to the forearm length
C2000
6.1.3 Control Panel
CAUTION
Risk of accidents and injury due to uncontrolled moving
of the wheelchair. Turn off the control unit of the power
wheelchair before mounting or removing the control panel
or changing its position.
NOTICE
Cable damage. Positioning the cable incorrectly can lead
to pinching and thus damage to the cable. The cable must
not be attached too tightly or too loosely. Avoid bending or
squeezing the cable.
Adapting the Control Panel to the Arm Length
The control panel is attached to a rail which is located beneath
the armrest.
1. Loosen the three set screws on the underside of the arm-
rest.
2. Move the control panel with the control panel receiver
along the attachment rail forwards or backwards into the
desired position.
01 / 2010
Operation
Page 129
Werbung
Kapitel
Inhaltsverzeichnis
