Adapting the Footrest(s) to the Lower Leg Length
1. Using a 13 mm open-end or combination wrench and a
6 mm Allen wrench, loosen the two screws between the
rails and remove them.
2. Move the footrest receiver with the footplate(s) along the
rail up or down to match another fixing hole.
3. Insert the screws into the fixing holes and firmly retighten
them.
Fig. 13
Adapting the footrest(s) to the lower leg length
C2000
Adapting the Calf Pads
The calf pads belong to the standard equipment of the C2000
power wheelchair. They are mounted to the rails for the at-
tachment of the footrests. Their position can be adapted to
the requirements of the user.
1. Using a 13 mm open-end or combination wrench loosen
the two screws from the mounting sheet and remove them.
2. To change the height, move the receiver with the calf pad
along the rail up or down to match another hole.
3. To change the depth setting, choose another hole in the
mounting sheet.
4. Insert the screws into the fixing holes and firmly retighten
them.
01 / 2010
Operation
Page 131