Control Panel; Fig. 14 Pulling Off The Swing-Away Control Panel; Fig. 15 Adapting The Control Panel - Otto Bock A200 Gebrauchsanweisung

6.1.4 Control panel
NOTICE
Cable damage. Positioning the cable incorrectly can lead
to pinching and thus damage to the cable. The cable must
not be attached too tightly or too loosely. Avoid bending or
squeezing the cable.
Remove the control panel
The control panel can be removed by pulling it to the front.
In case of a swing-away control panel (see section 7.3), pull
off the control panel from the ball head of the control panel
holder (Fig. 14).
Fig. 14 Pulling off the swing-away control panel
A200
Adapting the control panel to arm length
To adapt the control panel to the arm length of the user, you
must loosen the three screws on the underside of the arm-
rest (size 3) (see Fig. 15).
You can now slide the rail with the control panel backwards
and forwards. Firmly re-tighten the screws after making ad-
justments.
INFORMATION
If the control panel rail is too long, the protruding part can
simply be cut off with a saw.
Fig. 15 Adapting the control panel
Operation
Ottobock 101
|