Control Panel; Figure 13 Adapting The Control Panel - Otto Bock C1000 DS Gebrauchsanweisung

Operation

6.1.4 Control panel

CAUTION
Risk of accidents and injury due to uncontrolled move-
ments of the wheelchair. Before changing the position of
the control panel or installing/ removing it, turn off the con-
trol unit of the power wheelchair.
NOTICE
Cable damage. Positioning the cables incorrectly can
lead to pinching and damage to the cables. The cables
must not be attached too tightly or too loosely. Avoid bend-
ing or squeezing the cables.
Adapting the control panel to the arm length
The control panel is attached to a rail which is located be-
neath the arm rest.
1. Loosen the three set screws on the underside of the
arm rest using an Allen wrench size 3.
2. Move the arm rest with the control panel holder or re-
placement tube forward or backwards to the desired
position along the attachment rail.
3. Retighten all set screws.
162 Ottobock
|
Figure 13 Adapting the control panel
INFORMATION
If the control panel rail is too long, the protruding part can
simply be cut off with a saw.
Changing the control panel mounting side
The standard configuration has the control panel mounted
on the right side. If desired by the user, it can also be mount-
ed on the other side of the power wheelchair.
INFORMATION
Only authorised personnel may change the control panel
mounting side.
C1000 DS