Control Panel; Figure 9 Adjusting The Height Of The Arm Rest; Figure 10 Adapting The Control Panel - Otto Bock B600 Bedienungsanleitung

Figure 9 Adjusting the height of the arm rest

6.1.4 Control Panel

NOTICE
Cable damage. Positioning the cable incorrectly can lead
to pinching and damage to the cable. The cable must not
be too tight or too loose. Avoid bending or squeezing the
cable.
B600
Downloaded from www.Manualslib.com manuals search engine
Adapting the Control Panel to Arm Length
To adapt the control panel to the arm length, the 3 screws
on the bottom of the arm rest must be loosened with an Al-
len key (size 3) (see Figure 10). Now the control panel can
be moved backwards and forwards. The arm rest can be
adjusted in the same way.
Figure 10 Adapting the control panel
Firmly re-tighten the screws after making adjustments.
If the control panel rail is too long, the protruding
INFORMATION
part can simply be cut off with a saw.
02/2009
Operation
Page 117