External Mileage Counter; Mileage Counter - Otto Bock C200 Bedienungsanleitung

7.3.2 External Mileage Counter
INFORMATION
When using a separate LCD monitor, an external mileage
counter is not needed, because the LCD monitor has its
own mileage counter.
The external mileage counter is attached to the protective bow
for the control panel. The mileage counter shows:
n Speed
n Trip mileage
n Total mileage
n Digital clock
Fig. 32 Mileage counter
C2000
Whenever the display shows km/h or m/h in the upper left
corner, the speedometer is activated. Pressing the yellow
button lets you see the trip mileage, total mileage, digital clock
and speed one after the other.
Setting the Trip Mileage Back to Zero
Three flashing arrows on the left side of the display indicate
the trip mileage counter. To set the value back to zero, press
the yellow button for at least two seconds.
Setting the Time
If the digital clock is activated on the display, you may set the
time. Press the yellow button for at least two seconds. The
display will show 12: and 24: in turn. Pressing the button
again when the display shows 24: will programme the clock
to show a 24-hour display. Pressing the button when the
display shows 12: will result in a 12-hour display.
Next, the hours and minutes can be set. The time digits au-
tomatically advance one after the other. Press the yellow
button when the desired digits are showed on the display.
Setting the Total Mileage
When the total mileage counter is shown on the display, you
can switch between km/h and m/h and enter the wheel cir-
cumference. To do so, press the yellow button for at least 2
01 / 2010
Accessories
Page 161