4.2 Settings
The following tools are required to adjust the wheelchair to
the requirements of the user and for maintenance work:
n Allen wrenches, sizes 3 to 6
n Open-end or combination wrenches, sizes 8, 10, 13
n Phillips screwdriver
n Screwdriver for pan head screws
n Tyre repair accessories
4.3 Initial Operation
WARNING
Risk of suffocation. Packaging materials must be kept out
of reach of children.
All components must be checked for completeness and func-
tionality prior to initial operation. Before the C2000 power
wheelchair can be switched on, the 100 A fuse must be in-
serted into the fuse holder (see Fig. 3). The fuse holder is
located laterally on the drive unit sustainer, next to the charg-
ing receptacle.
C2000
To do so, remove the fuse from the protective cover on the
control panel, open the cap of the fuse housing and insert the
fuse.
Make sure that the fuse is pressed into the centre of the spring
contacts and that it is not at an angle.
Fig. 3
Fuse housing with inserted fuse
1 Fuse housing with open cap
2 Fuse
01 / 2010
Delivery and Preparation for Use
2
1
Page 121