6.9 Adjusting the height of the armrest for desk side panel
The armrest can be set to three different heights. In the standard assembly, the armrest is moun-
ted firmly onto the tube bend.
INFORMATION!
To increase the armrest height, remove the two cap screws completely from the tube
bend. Then place the two distance pieces above the tube bend between armrest
and side panel tube to adjust a further height.
INFORMATION!
Make sure to firmly retighten all screws and nuts after making adjustments.
6.10 Adjusting the seat depth (Fig. 31)
Undo the hook-and-loop attachment between back padding and seat upholstery.
Loosen the screw connections A that connect the rear wheel adapter to the open frame tube.
Remove the screws. The rear wheel adapter can then be shifted along the frame tube. Three
different seat depth adjustments, in 3 cm increments, are possible.
INFORMATION!
Make sure to firmly retighten all screws and nuts after making adjustments (6 Nm).
Fasten the hook-and-loop attachment again between the back padding and the
seat upholstery.
A
31
53