Drive Function - Otto Bock C200 Bedienungsanleitung

Operation
power wheelchair is switched off automatically. It is also
possible to switch off the power wheelchair with the on / off
button during driving. In this case, the wheelchair brakes
immediately until it stops.
INFORMATION
The parameter settings can be changed by the specialist
dealer in accordance with the user's desire in what speed
level or menu he / she wants the power wheelchair to be
after switching on.
6.3.3 Drive Function
CAUTION
Risk of injury due to uncontrolled operation of the power
wheelchair. Switch off the controls on the power wheelchair
whenever you do not need them. This will prevent you from
unintentionally activating the joystick.
CAUTION
Risk of injury due to tipping during operation. Observe
the following safety information when operating the power
wheelchair:
Page 136
n Short-term operation on inclines up to a maximum of
22 %.
n When driving downhill, reduce speed in accordance with
the degree of the incline.
n Do not cross differences in height of more than 14 cm.
n Do not cross steps or curbs without braking first.
The power wheelchair has been approved for ascending or
descending inclines of up to 22 %. Navigating inclines above
this percentage value is not permitted.
To ensure safe downhill driving, the driving speed must be
reduced in accordance with the degree of incline (e. g. set it
to speed level 1).
The critical obstacle height of the power wheelchair is maxi-
mally 14 cm (depending on the load and driving direction). It
is not permitted to cross obstacles higher than 14 cm. Ob-
stacles such as steps or curbs must be crossed at reduced
speeds.
If there are obstacles in the travel path, it is important to drive
around them with a large margin of safety. On uneven ground,
the driving behaviour of the wheelchair may get out of control.
Therefore the speed must always be adapted to the ground
conditions.
01 / 2010 C2000