Caster Wheel Replacement - Otto Bock C200 Bedienungsanleitung

NOTICE
Damage to tyres due to excessive tyre pressure. Make
sure that the tyre pressure indicated in Section 10 "Techni-
cal Data" is not exceeded.
INFORMATION
Direct sunlight (UV light) causes the tyres to age prema-
turely. As a result, the tread surface hardens and corner
pieces break out of the tread.
INFORMATION
Avoid parking the wheelchair outdoors whenever possible.
Regardless of wear and tear, replace the tyres every 2 years.
When the wheelchair is not used for extended periods of time
or if the tyres are heated strongly (e. g. near radiators or by
sunlight shining through a window), permanent deformation
of the tyres will result. Therefore always make sure that the
power wheelchair has sufficient distance from sources of
heat, move your wheelchair from time to time or jack up the
wheelchair when storing it.
C2000
9.3.1 Caster Wheel Replacement
Proceed as follows:
5. Turn off the controls.
6. Jack up the power wheelchair so that the wheel you want
to replace can rotate freely.
7. Loosen the four screws around the wheel hub.
8. Pull the caster wheel to the front off the wheel hub.
9. Put the new caster wheel onto the wheel hub.
10. T ighten all four screws with a torque wrench.
Properly reassemble all components upon completion of the
work.
INFORMATION
When installing the wheel, tighten all four screws to a torque
of 25 Nm.
01 / 2010
Maintenance and Care
Page 177