Maintenance and Care
NOTICE
When the joystick is activated while the brakes are unlocked,
the control system emits an error signal on the control
panel. If this is not the case, there is a malfunction that must
be corrected immediately by a specialist dealer.
9.2 Changing the Fuse
The 100 A fuse is located laterally on the drive unit sustainer,
next to the charging receptacle, in the fuse holder provided
for this purpose (see Fig. 37).
1. Open the cap of the fuse holder.
2. Pull out the fuse.
3. Insert the new fuse into the holder. Make sure that the fuse
is pressed into the centre of the spring contacts and that
it is not at an angle.
4. Close the cap until you feel it snap back into pla.
Page 176
Fig. 37
Changing the fuse
9.3 Wheel Replacement
NOTICE
Risk of damage due to uncontrolled movements. When
jacking up, secure the power wheelchair to prevent it from
slipping or tilting to the side by placing a suitable base under
the drive unit support.
01 / 2010
C2000