Otto Bock C200 Bedienungsanleitung Seite 111

NOTICE
Damage may be caused by improper use of the seat
height adjustment function. The C2000 power wheelchair
may be equipped with a seat height adjustment device. The
following particularities must be observed during operation:
n The seat function actuators are not intended for con-
tinuous use, but only for short-term limited operation
(10 % use, 90 % idle time). General recommendation:
At maximum load, 10 seconds of operation should be
followed by 90 seconds of idle time. In this regard, the
electric seat functions are considered independently of
the driving function.
n The seat with seat height adjustment function may only
be subjected to a maximum load of 160 kg / 200 kg.
n The seat height adjustment function may not be oper-
ated in case of errors or malfunctions.
n If creep speed is not activated when the seat height
adjustment function is operated, please visit a specialist
dealer immediately. The C2000 power wheelchair may
only be used with the seat height adjustment in its lowest
position until the fault is repaired.
C2000
NOTICE
Risk of damage due to excessive heat or cold. The C2000
power wheelchair may only be operated in the temperature
range from – 25 °C to + 50 °C. It must not be operated at
temperatures outside this range.
NOTICE
Risk of damage caused by overload. Depending on the
standard version, the maximum load capacity for the C2000
power wheelchair is 160 kg or 200 kg. It is possible to have
the C2000 power wheelchair retrofitted for a maximum load
of 260 kg.
NOTICE
Breakage due to overloading the luggage carrier. The
maximum load capacity for the luggage carrier is 15 kg.
NOTICE
Interference from electromagnetic fields. The power
wheelchair has been tested according to EMC regulations.
The following particularities must be observed during op-
eration:
01 / 2010
Safety
Page 111