Lcd Display - Otto Bock C200 Bedienungsanleitung

INFORMATION
Make sure a sufficient supply of power is maintained in
order to guarantee proper operation of the seat height adjust-
ment device.
INFORMATION
The seat height adjustment device is not intended for con-
tinuous use, but only for short-term limited operation (10 %
use, 90 % idle time). For every 1 hour of operation, the seat
height adjustment function can be used for a maximum of 6
minutes.
As an option, the C2000 power wheelchair may be equipped
with a seat height adjustment device. The seat height adjust-
ment function allows the seat to be raised by up to 40 cm
using a motor. The joystick in the "additional function" mode
is used to control this function (see Section 6.3.5).
The drive function remains available even when the seat is
raised. As soon as the seat leaves the lowest position, the
speed is reduced (creep speed) because the power wheelchair
is less tip-resistant. This is indicated by a snail symbol on the
control panel or the optional, separate LCD monitor.
C2000
Fig. 23 Creep speed – Control panel display / LCD display
01 / 2010
Operation
Page 151