Options' Menu - Prominent Dulcopool Pro Montage- Und Betriebsanleitung

Setting measuring and control parameters

'Options' menu

8.1.1
Tab. 18: Options > 'Installation options' sub-menu
Menu item
'Installation' locking code
'Settings' locking code
Use the installation code to lock
'Settings' level
the
'Options' menu on the
Lock the
'Settings' level.
Tab. 19: Options > 'General configuration' sub-menu
Menu item
'Automatically create a
parameter for each sensor' .
'Condition the flow rates only to
this parameter' .
' Condition the liquid level
sensors only to this parameter' .
'Enable the extended
configuration of the flow switch/
flow meter' .
88
Calculating The
measure‐ access the options available in the installation part.
ments
Outputs The
available in the installation part.
Conditions The
available in the installation part.
Communica‐ The
tion options available in the installation part.
Factory set‐ The
ting options available in the installation part.
Press on the respective menu item to move to the menu
item.
'Options' menu item to move to the menu item.
Press the
Function
Enable or disable the security code to access the
Enable or disable the security code to access the
'Installer' code to lock the 'Settings' menu
Use the
Lock and prevent access to the options in the
Press the right arrow key to move to the
configuration' selection screen.
Function
If this option is enabled, a measuring parameter corresponding to the
sensor type is created when a new sensor is added. It is still possible to
change and/or delete this parameter in a second step.
This option permits faster configuration for a simplified installation.
This option is used to separate the flow rate condition and the parameter
control. If this box is not checked, control is undertaken at sensor level
and the control levels need to be set separately for each parameter con‐
trolled. This means, for example, that the capacity is controlled differently
with acid than with chlorine. If this field is checked, only one control level
is defined for all control parameters.
The same principle as with the previous option, but for the liquid level
sensors 4 ... 20 mA.
If this box is checked, it is possible to manage the conditioning type
between the flow switch and the flow meters to switch conditioning on or
off. The logic conditions AND / OR can then be configured in the "Condi‐
tions" menu. If this box is not checked, the OR condition is active as
standard
'Calculating measurements' menu lets you
'Outputs' menu lets you access the options
'Conditions' menu lets you access the options
'Communication' menu lets you access the
'Factory setting' menu lets you access the
'Installation' menu.
'Settings' menu.
'Settings' menu
'General