ProMinent DULCOPOOL Pro Montage- Und Betriebsanleitung Seite 191

Main group Subgroup
I: Alarm notifications
1
2
3
4
Alarm threshold OFF if not programmed
II: Measured value and units
5
6
7
8
Control setpoint OFF if not programmed
III: Metering status and capacity
9
10
11
12
13
IV: Notification area
14
15
16
17
18
19
20
21
22
23
V: Alarm status area
24
25
Function
Technical alarm
Measured value too low
Measured value too high
Disabled setting
Measured value lower than can be displayed on the scale.
Measured value higher than can be displayed on the scale.
Measured value cannot be displayed.
Measured value cannot be measured. Technical alarm
No metering system available.
Metering is stopped (STOP).
Metering is paused.
No metering in progress.
Metering time bar when the maximum metering time is programmed.
Polarisation is in progress.
Check the water supply.
The power supply is disconnected.
The feed chemical storage tank is empty.
Overmetering. Overmetering has been detected.
Check the flow or flow volume.
The timer is active.
The sensor is not operating.
The sensor must be maintained and serviced.
The sensor signal is unstable and fluctuating.
Threshold low / threshold high
Measured value
Operating concept and operation
51