Werbung
TROUBLESHOOTING
Control was not
©
possible regardless of
what operation switch
was pressed.
If static electricity is pronounced, it is recom-
mended that you operate the unit using the
remote control unit.
© VOLUME is turned down.
® Raise volume.
speaker terminals.
© Consult page 14 — 21 and perform connections
correctly.
© Set correctly.
© Press the correct switch.
No picture is pro-
® Connections are incorrect.
duced, even when the
INPUT SELECTOR
switch is selected.
© The V- SIGNAL SELECTOR is not set properly.
© The VCR and the selected INPUT SELECTOR
switch are not correct.
© Tune the station in correctly.
® Connect the antenna securely.
¢ Station has not been tuned in to correct frequency.
© Antenna has not been connected or has become
disconnected.
FM reception
© Accessory T-type antenna remains bundied up or
it is not pointing in right direction.
© Weak broadcasting station signals.
High noise jevel.
© Stretch both ends of antenna taut and locate direc-
tion yielding optimum reception.
© Replace accessory T-type antenna with outdoor
FM antenna.
AM reception
© AM loop antenna is not pointing in right direction.
® Change the direction of AM loop antenna and find
a position where reception is improved.
¢ Erect outdoor AM antenna or connect ground wire.
@ Weak broadcasting station signals.
¢ Stop using appliances generating noise or remove
them from vicinity of the stereo equipment.
Separate the loop antenna from the unit by some
distance.
In general, when copy system connections are
made, the VCR's TV tuner function ceases to oper-
ate. For details, consult the operating instructions
for your VCR.
® Video tape copy connections haven't been made.
© Noise being picked up from this unit and other
equipment (especially electrical appliances using
motors or fluorescent lights).
® Look again closely at the section video system
connections on page 14 —
21, and connect cor-
rectly.
Video tape copies
can't be made with the
VCR.
114
<ARE1179>
En
Werbung
