Bosch REXROTH IndraMotion MTX 09VRS Anwendungsbeschreibung Seite 217

Anwendungsbeschreibung | Rexroth IndraMotion MTX 09VRS
The number of error message and mes‐
sage text
(#88) Es ist nicht möglich, einen oder me‐
here Breakpoints nach dem Laden einer
Konfigurationsdatei zu setzen. Die Break‐
points werden aus der Liste der Breakpo‐
ints gelöscht.
(#90) Nach dem Laden einer Konfigurati‐
onsdatei ist es nicht möglich, aktive
Breakpoints zu setzen, da der Test-
Modus nicht gesetzt ist.
(#20) Die Anzahl der Variablen kann nicht
ermittelt werden. (IVariable::GetNumberOf‐
Variable)
(#22) Der aktuelle Variablenwert kann nicht
ermittelt werden. (IVariable::GetVarValue)
(#28) Der aktuelle NC-Status kann nicht er‐
mittelt werden. (INcsChannel::GetNcState)
(#32) Der aktuelle NC-Mode kann nicht er‐
mittelt werden. (INcsChannel::GetNcMode)
(#50) Die Tiefe des Call-Stacks kann nicht
ermittelt werden. (IProgChain::GetProg‐
ChainDeep)
(#51) Die Parameter eines Unterprogram‐
mes können nicht ermittelt werden. (IProg‐
Chain::GetSubProgLevel)
(#80) Die Verbindung zur NC wurde unter‐
brochen.
The probable reason
Active flow program was absent at
the moment of loading information
from the configuration file.
The regime NC-Analyzer Mode
was not set.
The configuration file was written
during the work with another flow
program.
The flow program was edited after
its data were saved in the configu‐
ration file.
The regime DryRunMode was not
set.
Messages about problems of connection with NC
Timeout is too small.
Timeout is too small.
Timeout is too small.
Timeout is too small.
Timeout is too small.
Timeout is too small.
The break of connection with NC. Close the application and restart it, restoring
Electric Drives | Bosch Rexroth AG
and Controls
Erweiterte Funktionalität
Recommendations to a user
Load information from the configuration file
only after selecting active flow program.
Set NC-Analyzer Mode. Then (DryRunMode
also should be set) load information from the
configuration file.
Continue the work (information about break‐
points from this configuration file will be lost).
If it is necessary to save information about
breakpoints, written just in the configuration
file, with which the application was started,
then, save the configuration file with another
name for further usage, without closing the
application.
It is recommended to juxtapose configuration
files to concrete flow programs, and to start
flow programs only with their own configura‐
tion files. (For instance, it is possible to use
the name of the flow program for the name of
the configuration file: TEST.CPL
This message will not appear, if this recom‐
mendation is taken into consideration.
Continue the work (information about break‐
points from this configuration file will be lost).
Set DryRunMode, clicking the button General
Inhibit OFF. Then (NC-Anlyzer Mode also
should be set) load information from the con‐
figuration file.
Close the application, restart the application.
Close the application, restart the application.
Close the application, restart the application.
Close the application, restart the application.
Close the application, restart the application.
Close the application, restart the application.
the connection.
205/249
test.cld).