Replacing Filters In The Hydraulics Area - Bosch EPS 708 Originalbetriebsanleitung

en 58 | EPS 708 | Maintenance
6.8 Replacing filters in the hydraulics
area
¶
Remove the upper left cover (fig. 3, pos. 7) from the
back of the EPS 708.
CAUTION – Risk of injury from sharp edges
and burrs!
Sharp edges and burrs risk injuring the
hands during filter replacement.
¶
Wear protective gloves.
i
Make sure that the hydraulics area is always closed
with the cover following each filter replacement.
3
Fig. 22: Hydraulics area
1 Filter for pump return
2 Volume meter filter
3 Flow meter filter
|
1 689 989 067 2017-12-08
6.8.1
1
Fig. 23:
1 Volume meter filter
2 Screw clamps
1. Slacken the screw clamps (fig.23, pos. 2).
2. Pull the hoses off the filter (fig. 23, pos. 1).
3. Remove the volume meter filter and dispose of it.
4. Push hoses onto the new filter.
5. Secure the screw clamps.
"
458846-51_Ko
2
Replacing the volume meter filter
2
Replacing the volume meter filter
The filter is now changed.
1
Robert Bosch GmbH