Installation And Initial Commissioning - Bosch EPS 708 Originalbetriebsanleitung

en 44 | EPS 708 | Product description
The high-pressure hose has a replaceable adapter nut
on one side (see fig. 6, pos. 1). The adapter nut can be
changed, depending on the thread size of the high-
pressure outlet on the common rail pump. During use,
the adapter nut is screwed onto the high-pressure hose
and tightened. The scope of delivery includes three
adapter nuts for the following thread sizes:
Adapter nut
1 683 345 065
1 683 345 052
1 683 345 053
The bent test pressure lines 1 680 750 123 can be used
to connect the high-pressure hose 1 680 712 324 to
difficult-to-access high-pressure outlets. Adapter nut
1 683 345 053 (fig. 7, pos. 3) must be used to connect
the test pressure line to the high-pressure hose.
1
2
Fig. 7: Test pressure line 1 680 750 123
1 Adapter nut
2 Test pressure line 1 680 750 123
3 Adapter 1 683 345 053 (M16x1.5 – M18x1.5)
4 High-pressure hose 1 680 712 324
|
1 689 989 067 2017-12-08
Thread
M12x1.5 – M18x1.5
M14x1.5 – M18x1.5
M16x1.5 – M18x1.5
FD: 2010-09
458843-03_Pal
3 4
3.5.8 Lubricating oil supply (optional accessory)
The lubricating oil supply provides common rail pumps
that are not lubricated by fuel with lubricating oil during
test operation.
i
Information on installing the lubricating oil
supply can be found in installation instructions
1 689 978 558.
3.6

Installation and initial commissioning

The EPS 708 may only be brought into service by
Bosch Customer Service or authorized service agents.
Initial commissioning of the EPS 708 is described in
publication 1 689 978 559.
i
Assembly and connection of the printer (special
accessory) is described in the assembly instructions.
Robert Bosch GmbH