Symbols Used; In The Documentation - Bosch EPS 200 Umbauanleitung

1.

Symbols used

�.�

In the documentation

�.�.� Warning notices - Structure and meaning
Warning notices warn of dangers to the user or people in
the vicinity. Warning notices also indicate the consequenc-
es of the hazard as well as preventive action. Warning no-
tices have the following structure:
Warning KEY WORD – Nature and source of hazard!
symbol Consequences of hazard in the event of fail-
ure to observe action and information given.
¶
Hazard prevention action and information.
The key word indicates the likelihood of occurrence and
the severity of the hazard in the event of non-observance:
Key word Probability of
occurrence
DANGER Immediate impend-
ing danger
WARNING Possible impending
danger
CAUTION Possible dangerous
situation
�.�.� Symbols in this documentation
Symbol Designation Explanation
Attention Warns about possible property damage.
!
Information Practical hints and other
i
useful information.
1. Multi-step Instruction consisting of several steps.
2. operation
One-step Instruction consisting of one step.
e
operation
Intermedi- An instruction produces a visible inter-

ate result mediate result.
Final result There is a visible final result on comple-
"
tion of the instruction.
�.� On the product
!
Observe all warning notices on products and ensure
they remain legible.
Robert Bosch GmbH
Severity of danger if in-
structions not observed
Death or severe injury
Death or severe injury
Minor injury
Symbols used | � ��� ��� ��� | �
2. User instructions
�.� Important notes
Installation and/or repair may only be performed by
trained and instructed Service personnel at Robert
Bosch GmbH or by organizations appointed to do such
work by Robert Bosch GmbH. If the devices are opened
or modified by unauthorized persons, then all warranty
claims will be rendered null and void.
Electrical systems and resources may only be put into
operation when in proper operating condition (see
hereto also EDIS information 200108_084). This re-
quirement is deemed to have been fulfilled, if after
modification or repair (initial test) it has been ascer-
tained that requirements as specified by the electro-
technical rules have been adhered to. To this end tests
as under the type and scope of the measures defined
by the electrotechnical rules (e. g. in Germany BGV A3)
are to be conducted. The type and scope of tests are
specified in VDE 0701/0702 Section 1 within Germany.
Corresponding national specifications are to be ad-
hered to.
�.� Safety instructions
All the pertinent safety instructions can be found in the
separate manual "Important notes on and safety instruc-
tions for Bosch Diesel Test Equipment". These instruc-
tions must be carefully studied prior to start-up, con-
nection and operation of the 1 687 001 926 and must
always be heeded.
�.� Items required
R
General mechanics' tools
R
Strand tension gauge optibelt TT mini S
R
Loctite 243 locking compound
R
Universal puller, e.g. Nexus
(order number: 100 - 2.5)
R
Strap wrench for 200 mm pipe diameter,
e.g. Gedore (order number: 36 2-200)
�.4 Scope of delivery
R
Large HDT toothed belt sprocket
R
Small HDT toothed belt sprocket
R
HDT toothed belt
R
Stud M 6 x 8
R
Modification instructions 1 689 978 528
en
|
1 689 978 528 2012-04-18