Symbols Used; In The Documentation; Warning Notices - Structure And Meaning; Symbols In This Documentation - Bosch KTS 5a Serie Originalbetriebsanleitung

1.

Symbols used

1.1

In the documentation

1.1.1

Warning notices - Structure and meaning

Warning notices warn of dangers to the user or
people in the vicinity. Warning notices also indicate
the consequences of the hazard as well as preventive
action. Warning notices have the following structure:
KEY WORD – Nature and source of hazard!
Warning
Consequences of hazard in the event of
symbol
failure to observe action and information
given.
¶
Hazard prevention action and information.
The key word indicates the likelihood of occurrence
and the severity of the hazard in the event of non-
observance:
Key word Probability of
occurrence
DANGER Immediate
impending danger
Possible impending
WARNING
danger
CAUTION Possible dangerous
situation
1.1.2

Symbols in this documentation

Symbol Designation Explanation
Attention Warns about possible property
!
damage.
Information Practical hints and other
i
useful information.
1. Multi-step Instruction consisting of several
2. operation steps.
One-step Instruction consisting of one step.
e
operation
Intermediate An instruction produces a visible

result intermediate result.
Final result There is a visible final result on
"
completion of the instruction.
1.2

On the product

!
Observe all warning notices on products and
ensure they remain legible.
Disposal
Dispose of used electrical and electronic
devices, including cables, accessories and
batteries, separately from household waste.
Robert Bosch GmbH
Symbols used | KTS 560 / 590 (KTS 5a Series) | 15 |
Severity of danger if
instructions not observed
Death or severe injury
Death or severe injury
Minor injury
2.

User information

2.1

Important notes

Important information on copyright, liability and
warranty provisions, as well as on equipment users
and company obligations, can be found in the separate
manual "Important notes on and safety instructions
for Bosch Test Equipment". These instructions must
be carefully studied prior to start-up, connection and
operation of the KTS 560 / 590 (KTS 5a Series) and
must always be heeded.
2.2

Safety instructions

All the pertinent safety instructions can be found
in the separate manual "Important notes on and
safety instructions for Bosch Test Equipment".
These instructions must be carefully studied
prior to start-up, connection and operation of the
KTS 560 / 590 (KTS 5a Series) and must always be
heeded.
2.3

Electromagnetic compatibility (EMC)

KTS 560 / 590 (KTS 5a Series) satisfies the criteria of
the European Directive EMC 2014/30/EU.
Warning! This device is not intended for use in
residential environments, and it cannot ensure a
suitable degree of protection of radio reception in
such environments.
2.4

Measuring category

KTS 560 / 590 (KTS 5a Series) complies with the
general safety requirements for electrical testers,
measuring instruments and accessories in EN 61010-1
and EN 61010-2-030.
KTS 560 / 590 (KTS 5a Series) is designed for test and
measurement circuits with no direct mains voltage
system connection (Category I, motor vehicle testers).
en
|
1 689 989 223 2021-09-24