Notes Concerning The Multimeter And Oscilloscope; Firmware Update; Initial Commissioning; Installing Ddm - Bosch KTS 5a Serie Originalbetriebsanleitung

en | 20 | KTS 560 / 590 (KTS 5a Series) | Device description
3.6.3 Notes concerning the multimeter
and oscilloscope
Danger due to high voltage!
There is a risk of a potentially fatal voltage
when measuring high voltages.
¶
Always plug measurement cables into
the KTS modules first and then into the
vehicle.
¶
Only use the measurement cables provided
(with contact protection).
¶
Connect measuring leads CH1- and CH2-
as close as possible to the object being
measured.
¶
Use KTS modules only on the vehicle
and not for measuring voltage > 60 VDC,
30 VAC or 42 VACpeak. Do not perform any
measurements on ignition systems.
¶
Do not lay unshielded measurement cables
close to sources of major interference such
as ignition cables.
3.6.4

Firmware update

After an update of ESI[tronic] 2.0, the firmware of
the KTS module is updated automatically when the
controller diagnosis is started.
To update the firmware, the KTS module is to be
supplied with voltage from the power supply unit
provided and connected to a PC/laptop by way of
the USB connection cable. Do not interrupt the USB
connection during the firmware update. The firmware
update can also be done using DMC (Diagnostic
Module Configuration) (see online help on DMC).
!
For a KTS 560 / 590, firmware updates must always
be performed using the USB connecting cable (not
by way of Bluetooth).
|
1 689 989 223 2021-09-24
4.

Initial commissioning

4.1 Installing DDM (Diagnostics
Download Manager)
1. Install DDM.
i
For further information, see e-mail regarding the
ESI[tronic] contract.
2. Set up DDM.
i
For further information, see Help Center DDM,
which can be opened with "?".
"
ESI[tronic] 2.0 can be downloaded.
4.2 Installing ESI[tronic] 2.0
1. Start installation.
 Set-up will start.
2. Read and follow the instructions on the screen.
"
ESI[tronic] 2.0 is now installed and will be launched.
4.3 Obtaining a license for
ESI[tronic] 2.0
1. Accept the license agreement.
 The licensing information is displayed.
i
The licensing process is performed online or by
file. For further information, see ESI[tronic] 2.0
online help by selecting
2. Use the USB connecting cable to connect the
KTS 560 / 590 to the computer.
3. Start the licensing process.
4. Read and follow the instructions on the screen.
"
ESI[tronic] 2.0 is now licensed and will relaunch.
4.4

Configuring KTS 560 / 590

1. Start configuration.
2. If prompted, update the firmware.
3. Read and follow the instructions on the screen.
4. Configure the KTS 560 / 590.
i
For further information, see ESI[tronic] 2.0 online
help by selecting .
"
The KTS 560 / 590 is now configured.
4.5

Fitting the mounting bracket

The mounting bracket included in the scope of
delivery allows the fastening and releasing of the
KTS 560 / 590 on a Bosch trolley.
.
Robert Bosch GmbH