Operating System - IFM Electronic ecomot mobile R 360 Serie Starterset-Handbuch

Online test
and RS 232/TxD. Above it there is the marking CAN
that the CAN bus can be connected to the unassigned terminals.
A power supply is integrated in the control panel used during the trainings. As
long as you work with the simulator, the supply voltage can be taken via the
CAN connection because the supply voltage is on the same potential in the
whole (simulator) system.

Operating system

In principle, the steps for loading the operating system must be executed only
once. When the system is delivered, no operating system is stored in the
controller. It must be loaded only once. The procedure must only be repeated
(again only once) when a new version of the operating system is required. This
shows how flexible the control system is. For a PC for example the installation
of a new BIOS required the exchange of an EPROM. This was only successful
if hardware compatibility was checked thoroughly. This has only changed for the
current version. For the ecomat R360 only the software has had to be loaded.
For the controller in the starter kit the operating system (and the first test
program) has already been loaded.
If you have to load another operating system version or if you want to load an
operating system into a new controller, use the program downloader. This
program is on the CD "Software, tools and documentation" and can be installed
via the installation platform. Here you will also find the description of the
downloader,
If you have not prepared this step, the downloader will now have to be installed.
Start set-up as described in 2.2, Figure 4 to Figure 6. By clicking 'ecolog
downloader' , Figure 81 will take the place of Figure 6.
3-32
2.2.
and CAN to point out
H L